Compress Image to 20KB

Already set to 20KB for the smallest uploads on a form: signature, thumb impression and the tiny ID photo.

Files are processed on this page and are not uploaded.

Searches for compress image to 20KB almost always come from three boxes on an application form: the scanned signature, the left thumb impression and the small colour photograph some portals cap here. All three are mostly white paper or plain wall, which a JPG stores for almost nothing, so the bytes go to the ink, the ridges or the face.

The “Maximum file size” box already reads 20 and work starts as soon as a file lands. JPG, PNG, WebP, HEIC or TIFF go in; a JPG of 20KB or less comes out. Whether you typed “image to 20 kb” or image compressor to 20kb, the notes below cover the notices, the crop and the 10 KB floor.

Before and after

Before
A hand signing a sheet of paper with a pen at a desk

4032 × 2691 px1.51 MBJPG

After
The same photo compressed to 19.7 KB

876 × 585 px19.7 KBJPG

This photo was 1.51 MB. With the limit set to 20 KB, it came out at 19.7 KB, which is 99% smaller.

To fit, the tool also scaled the picture down from 4032 × 2691 px to 876 × 585 px.

The image on the right is the actual file the tool above produced.

How to use it

  1. Sign with a black pen on white paper, or press an inked thumb onto the sheet, and photograph it from straight above in daylight.
  2. Crop first: a wide strip round a signature, a square round a thumb print, head and shoulders for a photo. Use the crop tool if your camera app cannot.
  3. Add the cropped file. The highest JPG quality under 20KB is found by halving the search range repeatedly; pixels are cut only when no quality setting fits.
  4. Check the bytes and dimensions on the result card. If the notice names a floor too, tick “My form also has a minimum size”, enter it and run again.

The notices that set a 20 KB cap

The cap almost always means the signature. Staff Selection Commission notices for CGL 2026, CHSL 2026, MTS 2025, Constable GD 2026, Stenographer 2026 and Junior Engineer 2026 ask for JPEG/JPG, 10 KB to 20 KB, about 6.0 cm (width) x 2.0 cm (height). Banks give pixels: IBPS (PO/MT, CSA, SO, RRB) and State Bank of India (PO and Junior Associates 2025) want JPG/JPEG, 10 KB to 20 KB, 140 x 60 pixels (preferred), black ink on white paper, not in capital letters.

TNPSC’s Group II and IIA notification describes a 6.0 x 2.0 cm box (230 pixels x 75 pixels) at 200 DPI, 10 KB to 20 KB, JPG; its resize guide says to reduce the pixels until the file is less than 20 kb. The TANGEDCO exam cell wants 4.0 cm x 2.0 cm (preferred) at 200 DPI, 10 KB to 20 KB, JPG/JPEG. The one photograph here is Protean’s PAN application, Form 49A / 49AA: colour JPEG, 3.5X2.5 cms, 200 DPI, 20 KB at most.

What 20KB holds and why photos shrink

Treat the limit as a budget that content spends. A signature spends almost nothing on paper, so the ink can stay 500 to 700 pixels wide, far more than the notices ask. A thumb impression is dearer, its ridges being fine dark lines; expect around 250 to 350 pixels square. A face costs most and usually ends near 300 to 400 pixels on the longer side.

That budget is why a photo comes back with fewer pixels. A 12-megapixel file cannot fit in 20,480 bytes at any JPG quality, so when quality alone cannot get there, width and height are cut a step at a time and the search repeats. Camera settings and the preview tucked inside a phone JPG, worth several kilobytes, are left out, GPS included, and sideways shots come out upright.

Crop, white paper and the 10 KB floor

Miniature and blurred are the notices’ words for summary rejection. A signature on an A4 sheet shot from standing height is a small mark in a field of white, and at 20KB the strokes dissolve. Crop to a strip about three times as wide as it is high, with a slim white border. Grey paper, hand shadows and ruled lines add texture, which costs bytes that are then taken back from the ink.

Nearly every signature field above adds a 10 KB floor, and a clean crop on white paper often weighs 6 or 7KB at full quality. Tick “My form also has a minimum size”, type 10 and compress again. Quality rises first; if the file is still too light the picture is enlarged, up to three times, until it crosses the floor. A signature too sparse to get there is reported, not saved; sign larger and shoot again.

Frequently asked questions

Why does the form say 10 KB to 20 KB, not just 20 KB?
The notices do not say, but under 10 KB usually means a tiny or faint signature, the kind rejected as miniature. Tick the minimum box, enter 10, and the result stays between the two.
Will my signature keep its 6.0 × 2.0 cm or 140 × 60 pixel size?
Pixels are cut only when no quality setting reaches 20KB; a centimetre size is not written into the file. Make the exact strip with the resize signature tool first; at 140 × 60 it is usually under 20KB already.
Can a thumb impression reach 20KB without losing the ridges?
Usually, if the print is dark and the crop tight. A print filling the frame at around 300 pixels square keeps them; one sitting small in a wide photo loses them. Use an ink pad and press once without rolling.
Does this page do the photograph too?
Only where the photo limit is 20 KB, as on the PAN form. Bank and commission photographs usually allow 20 KB to 50 KB, so change the size box or use the 50KB page. One file at a time: photo and signature are two runs.
Is 20KB on this page 20,000 bytes or 20,480 bytes?
It is 20,480, since a kilobyte is 1,024 bytes here, as in Windows Properties and most portals. Where a notice says “less than 20 kb”, type 19 in the “Maximum file size” box to leave a margin either way.
My scanner saved a PDF. Can it become an image of 20 KB here?
Not directly; PDFs are not read here. Export the scan as JPG or PNG from the scanner app, or use the PDF to JPG tool first, then add the picture.